Laser Diode Driver 14A 30V incl. TEC Controller 10A 20V (1 Module Slot)

1,585.00

Compatible Cooling and Heating Plates

Air Cooling and Heating Plate 25W Heat Transfer (2 Module Slots)

Water Cooling and Heating Plate 75W Heat Transfer (1 Module Slot)

Temporarily unavailable

Water Cooling and Heating Plate 150W Heat Transfer (2 Module Slots)

SKU: M1LDCTC3014 Category:

Description

  • Output voltage / current: 1 – 30 V / 0 – 14 A[1]
  • Current setpoint resolution < 0.5 mA
  • Current ripple (typ. < 0.5% @ 10A, 500kHz)
  • Input voltage 15 – 36 V (M0101LDCTC3014)
  • Input voltage 15 – 48 V (M0101LDCTC4108)
    (>15% above output voltage)
  • Efficiency up to 96 %
  • TEC controller output: +-20 V / 0 – 10 A
    (bipolar, max 75 % of input voltage)
  • Temperature stability of PID controller: typ. 0.001 K
  • Dynamic air cooled electronics, no heat sink needed
  • Compatible with temperature plates M2TPA25, M4TPA50, M1TPW75 & M2TPW150
  • Overheating protection
  • Connectors for peltier element and NTC 10 kOhm
  • Fully daisy chainable:
    – 2 x power connectors[3]
    – 2 x isolated RS485 connectors
    – unique device address
  • Interlock header (LD driver disabled if open)
  • ASCII command set (SCPI* structure)
  • LED indicators for power/warning/error (can be disabled by dip switches)
  • Size 62.5mm x 62.5mm (1 x 1 grid units)
  • Demo files for LabVIEW™ & Matlab™ on request
  • Converters available for Ethernet or USB

*Standard Commands for Programmable Instruments

[1] For input voltages above 24V maximum output current decreases with low output voltages. (see graph)

[2] Vout minimum is approx.. 3% of input voltage.

[3] 10A max per connector. For higher currents both connectors must be used as parallel inputs.

CLICK HERE TO DOWNLOAD THE DATA SHEET