Description
- Output voltage / current: 1 – 30 V / 0 – 14 A[1]
- Current setpoint resolution < 0.5 mA
- Current ripple (typ. < 0.5% @ 10A, 500kHz)
- Input voltage 15 – 36 V (M0101LDCTC3014)
- Input voltage 15 – 48 V (M0101LDCTC4108)
(>15% above output voltage) - Efficiency up to 96 %
- TEC controller output: +-20 V / 0 – 10 A
(bipolar, max 75 % of input voltage) - Temperature stability of PID controller: typ. 0.001 K
- Dynamic air cooled electronics, no heat sink needed
- Compatible with temperature plates M2TPA25, M4TPA50, M1TPW75 & M2TPW150
- Overheating protection
- Connectors for peltier element and NTC 10 kOhm
- Fully daisy chainable:
– 2 x power connectors[3]
– 2 x isolated RS485 connectors
– unique device address - Interlock header (LD driver disabled if open)
- ASCII command set (SCPI* structure)
- LED indicators for power/warning/error (can be disabled by dip switches)
- Size 62.5mm x 62.5mm (1 x 1 grid units)
- Demo files for LabVIEW™ & Matlab™ on request
- Converters available for Ethernet or USB
*Standard Commands for Programmable Instruments
[1] For input voltages above 24V maximum output current decreases with low output voltages. (see graph)
[2] Vout minimum is approx.. 3% of input voltage.
[3] 10A max per connector. For higher currents both connectors must be used as parallel inputs.